Cut pipes: Use a pipe cutter or a light saw to bring the pipe to an accurate length. Make sure to cut it at the right angles.
Chamfer pipe ends: Chamfer the pipe ends with a chamfering tool. A file can be used as well.
Debur pipe ends: use a deburrer to debur pipe ends.
Measure insertion depth.
Mark depth: following, mark the insertion depth at the end of the pipe.
Clean pipe and fitting: ensure that both, the pipe and the fitting, are perfectly cleaned. Use a clean piece of paper tissue for each. Surfaces to be bonded must be completely dry before applying the adhesive.
Stir the product and soak the brush well with the adhesive.
Apply adhesive on the inside of the fitting: Slightly apply a thin layer of Tangit on the inside of the fitting in the direction towards the end of the pipe.
Apply adhesive to the pipe end: cover the marked area of the pipe and actively, apply a thicker layer to the pipe end with firm brush pressure.
Insert pipe into the fitting: Immediately afterwards, insert the pipe into the fitting to its full depth without twisting and align them correctly. Then, carefully remove the excess adhesive with absorbent paper.